TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 169 of 856
INSTALLATION - Continued NOTE Center bolt (Figure 5, Item 13) is installed through clip (Figure 5, Item 10) into oil cooler assembly (Figure 5, Item 9). 6. Loosely install three flat washers (Figure 5, Item 11), three new lockwashers (Figure 5, Item 12), and three bolts (Figure 5, Item 13) on oil cooler assembly (Figure 5, Item 9). Remove two oil cooler studs (Figure 4, Item 40). 7. Install transmission oil cooler bracket (Figure 5, Item 14), five flat washers (Figure 5, Item 17), five new lockwashers (Figure 5, Item 16), and five bolts (Figure 5, Item 15) on oil cooler assembly (Figure 5, Item 9). 8. Install bracket (Figure 5, Item 21), two flat washers (Figure 5, Item 20), two new lockwashers (Figure 5, Item 19), and two bolts (Figure 5, Item 18) on transmission oil cooler bracket (Figure 5, Item 14). 9. Torque two bolts (Figure 5, Item 18), five bolts (Figure 5, Item 15), and three bolts (Figure 5, Item 13) to 13–17 lb-ft (18–23 N·m). 10. Slide hose (Figure 5, Item 7) and two clamps (Figure 5, Item 8) onto oil cooler assembly (Figure 5, Item 9). 11. If removed, install pipe plug (Figure 5, Item 4) in elbow (Figure 5, Item 5). 12. Insert elbow (Figure 5, Item 5) into hose (Figure 5, Item 7) and install new gasket (Figure 5, Item 6), elbow (Figure 5, Item 5), two new lockwashers (Figure 5, Item 2), and two bolts (Figure 5, Item 1) on cylinder block. On model 5063-5393, the front (left) bolt goes through clip (Figure 5, Item 3) on hose (Figure 5, Item 40). Torque bolts to 13–17 lb-ft (18–23 N·m). 13. Adjust hose (Figure 5, Item 7) and two clamps (Figure 5, Item 8) between elbow (Figure 5, Item 5) and oil cooler assembly (Figure 5, Item 9) with clamp adjusting screws facing front of engine. Tighten clamps securely. MAINT_067 15 16 17 18 19 20 21 14 1 2 3 40 4 5 6 7 8 9 10 11 12 13 Figure 5. Engine Oil Cooler Hardware Installation. END OF TASK TM 9-2815-205-24 0022 0022-7