TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 168 of 856
INSTALLATION 1. If removed, install pipe plug (Figure 4, Item 34) in bottom of oil cooler housing (Figure 4, Item 33). 2. Install two oil cooler studs (Figure 4, Item 40) in positions (A) and (B). 3. Install new gasket (Figure 4, Item 22), oil cooler adaptor (Figure 4, Item 23), two flat washers (Figure 4, Item 24), two new lockwashers (Figure 4, Item 25), two large screws (Figure 4, Item 26), flat washer (Figure 4, Item 27), new lockwasher (Figure 4, Item 28), and small bolt (Figure 4, Item 29) on cylinder block. Torque two screws (Figure 4, Item 26) to 30–35 lb-ft (41–47 N·m) and bolt (Figure 4, Item 29) to 13–17 lb-ft (18–23 N·m). NOTE Some older oil cooler elements have “IN" and “OUT" stamped on the ports. If the element is so marked, install the port marked "IN" toward front of engine. 4. Install new gasket (Figure 4, Item 30), oil cooler element (Figure 4, Item 31), and new gasket (Figure 4, Item 32) on oil cooler studs (Figure 4, Item 40) and slide gaskets (Figure 4, Items 30 and 32) and element (Figure 4, Item 31) up against cylinder block. 5. Place oil cooler housing (Figure 4, Item 33) on studs (Figure 4, Item 40) and slide up against cylinder block. 26 25 24 27 28 29 23 22 30 31 32 33 34 40 A B MAINT_066 Figure 4. Engine Oil Cooler Installation. TM 9-2815-205-24 0022 0022-6