TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 160 of 856
INSTALLATION - Continued 6. Install four flat washers (Figure 7, Item 9), four new lockwashers (Figure 7, Item 10), two short bolts (Figure 7, Item 11) with lower rear bolt through clip (Figure 7, Item 8), and two long bolts (Figure 7, Item 16) in oil cooler assembly (Figure 7, Item 12). 7. Remove two guide studs (Figure 6, Item 28) and install remaining two flat washers (Figure 7, Item 9), two new lockwashers (Figure 7, Item 10), and two long bolts (Figure 7, Item 16). 8. Install three long studs (Figure 6, Item 28) and short stud (Figure 6, Item 27) on oil cooler assembly (Figure 7, Item 12). 9. Install four flat washers (Figure 7, Item 13), four new lockwashers (Figure 7, Item 14), and four nuts (Figure 7, Item 15) on studs (Figure 6, Items 27 and 28). 10. Torque two bolts (Figure 7, Item 11) and four bolts (Figure 7, Item 16) to 13–17 lb-ft (18–23 N·m). Torque four nuts (Figure 7, Item 15) to 15–19 lb-ft (20–26 N·m). 11. Slide hose (Figure 7, Item 6) and two clamps (Figure 7, Item 7) onto oil cooler assembly (Figure 7, Item 12). 12. If removed, install pipe plug (Figure 7, Item 17) in elbow (Figure 7, Item 4). If removed, install clip (Figure 7, Item 3) on air box heater fuel line (Figure 7, Item 46). NOTE Front bolt (Figure 7, Item 1) is installed through clip (Figure 7, Item 3), on fuel line (Figure 7, Item 46), into elbow (Figure 7, Item 4). 13. Slide elbow (Figure 7, Item 4) into hose (Figure 7, Item 6) and install new gasket (Figure 7, Item 5), elbow (Figure 7, Item 4), two new lockwashers (Figure 7, Item 2), and two bolts (Figure 7, Item 1) on cylinder block. Torque bolts to 13–17 lb-ft (18–23 N·m). 14. Adjust hose (Figure 7, Item 6) and two clamps (Figure 7, Item 7) between elbow (Figure 7, Item 4) and oil cooler assembly (Figure 7, Item 12) with clamp adjusting screws facing front of engine. Tighten clamps securely. TM 9-2815-205-24 0021 0021-10