TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 148 of 856
INSTALLATION 1. Install two guide studs (Figure 6, Item 16) into cylinder block at positions (A) and (B). 2. Install new gasket (Figure 6, Item 19), oil cooler element (Figure 6, Item 18), and new gasket (Figure 6, Item 17) on guide studs (Figure 6, Item 16) with port marked “IN" toward front of engine and slide gaskets (Figure 6, Items 19 and 17) and element (Figure 6, Item 18) against cylinder block. 3. Position oil cooler assembly (Figure 6, Item 15) on guide studs (Figure 6, Item 16) and slide up against cylinder block. 4. Install three flat washers (Figure 6, Item 22), three new lockwashers (Figure 6, Item 21), and three bolts (Figure 6, Item 20) in oil cooler assembly (Figure 6, Item 15). Torque bolts to 13–17 lb-ft (18–23 N·m). 17 18 19 16 16 15 22 21 20 B A MAINT_054 Figure 6. Oil Cooler Element Installation. 5. Remove two guide studs (Figure 7, Item 16) and install five flat washers (Figure 7, Item 3), five new lockwashers (Figure 7, Item 2), and five bolts (Figure 7, Item 1) in oil cooler assembly (Figure 7, Item 15). Torque bolts to 13–17 lb-ft (18–23 N·m). 6. If removed, install pipe plug (Figure 7, Item 12) in elbow (Figure 7, Item 5). 7. Slide hose (Figure 7, Item 10) and two clamps (Figure 7, Item 9) onto oil cooler assembly (Figure 7, Item 15). 8. Slide elbow (Figure 7, Item 5) into hose (Figure 7, Item 10) and install new gasket (Figure 7, Item 4), elbow (Figure 7, Item 5), two flat washers (Figure 7, Item 6), two new lockwashers (Figure 7, Item 7), long bolt (Figure 7, Item 13) through clip (Figure 7, Item 14) on hose (Figure 7, Item 11), and short bolt (Figure 7, Item 8) on cylinder block. Torque bolts to 13–17 lb-ft (18–23 N·m). 9. Adjust hose (Figure 7, Item 10) and two clamps (Figure 7, Item 9) between elbow (Figure 7, Item 5) and oil cooler assembly (Figure 7, Item 15) with clamp adjusting screws facing front of engine. Tighten clamps securely. TM 9-2815-205-24 0020 0020-10