TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 137 of 856
CLEANING WARNING Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure to comply may result in injury, illness, or death to personnel. WARNING Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result in injury to personnel. Clean parts with dry cleaning solvent and dry with compressed air. END OF TASK INSPECTION-ACCEPTANCE AND REJECTION CRITERIA Inspect all parts for damage and excessive wear. Replace as necessary. END OF TASK ASSEMBLY 1. If removed, install nipple (Figure 2, Item 11) in adapter (Figure 2, Item 10). Torque nipple to 70–80 lb-ft (95–108 N·m). 2. Lightly coat seal of oil filter spin-on element (Figure 2, Item 9) with clean engine oil. CAUTION Do not use mechanical means to tighten spin-on oil filter. Over-tightening will damage seal and filter. 3. Place oil filter spin-on element (Figure 2, Item 9) on adapter nipple (Figure 2, Item 11) and tighten by hand until seal contacts adapter (Figure 2, Item 10). Then turn oil filter element an additional two-thirds revolution. END OF TASK TM 9-2815-205-24 0019 0019-3