TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 121 of 856
INSTALLATION 1. If removed, install clip (Figure 1, Item 10) on tube assembly (Figure 1, Item 8). Loosely install tube assembly in adaptor (Figure 1, Item 7). 2. Install bracket (Figure 1, Item 2), two new lockwashers (Figure 1, Item 3), and two screws (Figure 1, Item 4) on flywheel housing. Torque screws to 16–20 lb-ft (22–27 N·m). 3. Install screw (Figure 1, Item 9), clip (Figure 1, Item 10), tube assembly (Figure 1, Item 8), new lockwasher (Figure 1, Item 6), and nut (Figure 1, Item 5) on bracket (Figure 1, Item 2). Torque screw to 30–35 lb-ft (41–47 N·m). 4. Tighten tube assembly (Figure 1, Item 8) at adaptor (Figure 1, Item 7). 0.46 in. (1.17 cm) 27.25 in. (69.22 cm) 25.94 in. (65.89 cm) MAINT_041 Figure 2. Oil Level Gauge Rod Cutting Instructions. NOTE A replacement oil gauge rod is 61 inches (155 cm) when packaged. 5. Cut and mark a new oil gauge rod as shown in Figure 2. 6. Install oil gauge rod (Figure 1, Item 1) in tube assembly (Figure 1, Item 8). END OF TASK END OF WORK PACKAGE TM 9-2815-205-24 0014 0014-3/blank