TM-9-2815-205-24 Technical Manual for M113 Engine 6V53 6V53T Download
Page 106 of 856
INSTALLATION 1. Slide hose (Figure 7, Item 3) and two clamps (Figure 7, Item 2) onto transmission oil cooler and engine water outlet housing (Figure 7, Item 1). WARNING Components of this engine are heavy and awkward to handle. Use correct lifting procedures, indicated lifting devices, and/or assistance from other personnel. Failure to comply may result in injury to personnel. 2. Use gasket adhesive to hold new gasket (Figure 7, Item 28) on transmission oil cooler bracket (Figure 7, Item 24) and install transmission oil cooler assembly (Figure 7, Item 4) on bracket with ports facing rear of engine. 3. Loosely install eight flat washers (Figure 7, Item 25), eight new lockwashers (Figure 7, Item 26), and eight screws (Figure 7, Item 27) securing bottom of transmission oil cooler assembly (Figure 7, Item 4) to bracket (Figure 7, Item 24). 4. Slide other end of hose (Figure 7, Item 3) over top of transmission oil cooler assembly (Figure 7, Item 4). Position and tighten clamps (Figure 7, Item 2) on ends of hose. 5. Guide two flat washers (Figure 7, Item 22), two new lockwashers (Figure 7, Item 21), and two screws (Figure 7, Item 20) onto bracket (Figure 7, Item 23). 6. Torque screws (Figure 7, Item 27) and (Figure 7, Item 20) to 13–17 lb-ft (18–23 N·m). 7. Torque screws (Figure 7, Item 41) and (Figure 7, Item 42) to 30–35 lb-ft (41–47 N·m). 20 21 22 24 25 26 27 4 28 23 2 3 2 1 23 42 41 MAINT_021 Figure 7. Transmission Oil Cooler Installation. TM 9-2815-205-24 0011 0011-8