Sign up to sell your inventory with NSN Lookup

TM-9-2540-207-14&P Sustainment Manual for A20 Heater for M113 2540-01-396-2826 Download

Page 63 of 288

TM 9-2540-207-14&P 5-19 Vent Fan Assembly Procedure for Design Iteration 3 (Continued) 3. Disconnect Wiring Harness connection J11 to the Vent Fan Driver Board. Figure 5.6-5 Vent Fan Assembly Note: To release the small Logic connector J13, use a 1/8" flat blade screwdriver. !CAUTION! Ensure the edge of the screwdriver blade does NOT nick the connector wires while unscrewing the connector. 4. Disconnect Wiring Harness connection J13 to the Electronic Programmed Controller Board by carefully putting the blade of the screwdriver between the connector sections. Gently pull up on the connector while using the blade of the screwdriver to aid in separating the halves of the connector.