TM-9-2540-207-14&P Sustainment Manual for A20 Heater for M113 2540-01-396-2826 Download
Page 60 of 288
TM 9-2540-207-14&P 5-16 Vent Fan Assembly Design Iteration 1 and 2 (Continued) Note: To release the small Logic connector J1, use a 1/8" flat blade screwdriver. !CAUTION! Ensure the edge of the screwdriver blade does NOT nick the connector wires while unscrewing the connector. 4. Disconnect Wiring Harness connection J1 to the Electronic Programmed Controller Board. Figure 5.6-3 Bolt Removal Detail, Vent Fan Assembly 5. Use a 5/16" socket to remove the bolt that holds the Vent Fan to the Burner Housing. !CAUTION! Take care not to damage the Combustion Air Duct during Vent Fan removal. 6. Gently pull the Vent Fan Assembly away from the Burner Housing Assembly. 7. While holding the Vent Fan Assembly with one hand, remove the Wiring Harness connector J1 from the Electronic Programmed Controller by squeezing with fingers and separating.