TM-9-2540-207-14&P Sustainment Manual for A20 Heater for M113 2540-01-396-2826 Download
Page 161 of 288
TM 9-2540-207-14&P 5-117 Burner Fan Driver Board Removal (continued) 2. Disconnect the Burner Fan Motor J3 Power connector. 3. Remove Diagnostic Display (ref. 5.9.2). 4. Using a 3/8” open-ended wrench, remove the four (4) hex standoffs. 5. Using a #1 cross tip screwdriver remove the two (2) securing screws from the driver board heat sink. Gently remove the driver board, taking care to not damage the driver board or heat sink. 5.10.3.2 Installation 1. Apply Dow Corning 340 heat sink compound to the mating surface of the driver board heat sink. Note: Ensure there are no contaminates on the mating surface that will impede cooling of the heat sink to the Burner Fan Plate. 2. Place the driver board over the four (4) pem studs on the burner fan plate. Gently ease the board into place, ensure the screws for the connector board line up. 3. Using a 3/8” open-ended wrench, replace the four (4) hex standoffs. 4. Using a #1 cross tip screwdriver replace the two (2) securing screws into the connector board. 5. Connect the J2 Wiring Harness connector. 6. Connect the J3 Power connector. 7. Install Diagnostic Display (ref 5.9.2). 8. Replace the Top Cover (ref. 5.4.1). 9. Replace vehicle power cable from the MS Power connector. 5.10.4 Burner Fan Impeller