TM-9-2540-207-14&P Sustainment Manual for A20 Heater for M113 2540-01-396-2826 Download
Page 150 of 288
TM 9-2540-207-14&P 5-106 Wiring Harness (continued) 5.9.8.2.1 Removal 1. Remove Top Cover (ref TM 5.4.1). 2. Remove Top Shell (ref. TM 5.4.2). 3. Remove Bottom Shell (ref.TM 5.4.3). 4. Disconnect the modular connectors (1,2) that attach to the Vent Fan Driver Board. 5. Disconnect the fuel line (3) to the burner. 6. Disconnect the modular connector (4) from the vent temp sensor. 7. Using a 7/16" open ended wrench, remove the Burner Sensor from the Port. 8. Using a 7/16" open ended wrench, remove the Exhaust Sensor from the Port. 9. Using pliers, release the 1" metal spring clamp at the Secondary Air Duct from the Heat Exchanger end. Slide the spring clamp over the hose and release onto the Top Housing end so that the Secondary Air Duct and two spring clamps are attached to Top Housing. Be careful that the spring clamp does NOT damage the Secondary Air Duct. !CAUTION! DO NOT set the Top Housing on the Secondary Air Duct Hose. Place the Top Housing on it’s side with the fuel inlet fitting facing upwards. 10. Using a #2 cross-tip screwdriver, remove the four (4) screws that hold the Top Housing to the Heat Exchanger. Lift the Top Housing away from the Heat Exchanger. 11. Remove Wiring Harness connectors from the Fuel Injector (5), (rotate the Injector upwards to release the connector), the Fuel Pump (6), EMI board (7), Diagnostic Display (8) and the Power Board (9). 12. With the Top Housing on its side, use a #2 cross-tip screwdriver to remove the screw holding the Power and Wiring Harness P-clip (10) attached to the underside of the Top Housing. 13. Remove the Fuel Pump (ref. TM 5.9.3) to allow access to Wiring Harness Plate. 14. Using a #2 cross-tip screwdriver, remove the four (4) self tapping screws from the Wiring Harness feed-thru plate by which it is fastened to the Top Housing. Remove the Plate. 15. Remove Wiring Harnesses from Wiring Harness Plate by sliding grommets out of keyed slot in Wiring Harness Plate. 16. Remove Wiring Harness by sliding it through the Top Housing.