TM-9-2540-207-14&P Sustainment Manual for A20 Heater for M113 2540-01-396-2826 Download
Page 117 of 288
TM 9-2540-207-14&P 5-73 5.9.3 Fuel Pressure Sensor 5.9.3.1 Fuel Pressure Sensor (For All Design Iterations) Figure 5-7. Fuel Pressure Sensor 5.9.3.1.1 Removal 1. Remove Top Cover (ref. 5.4.1). Note: The connector is released by gently lifting the locking tab with the blade of the small screwdriver, and then pulling apart the two halves. 2. Disconnect Fuel Pressure Sensor connector (J4) from the Wiring Harness. ! CAUTION ! If the Fuel Pressure Sensor is dropped, it may be damaged and should be replaced. J4 Logic Connector Fuel Pressure Sensor Note that the fuel manifold will look different in Design Iteration 1 but the procedure is the same.