TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 98 of 620
TM 9-2520-272-40 0014 INSTALL WIRING HARNESS ASSEMBLY NOTE Wiring harness may be removed/installed whenever the top cover has been removed. However, when all top components of transmission have been removed, for ease of installation install the wiring harness after the separator plate has been installed and before the valve bodies are installed. Harness should be connected to solenoids and ground after valve assemblies have been installed. 1. Install new gasket (Figure 3, Item 10) on wiring harness (Figure 3, Item 9). Pull wiring through gasket until gasket is under wiring harness connector body (Figure 3, Item 5). NOTE When the wiring harness was removed, a 30 in. (762 mm) length of twine may have been installed as an aid to installation. If twine is still tied to connector F or G, pull twine and feed wiring harness through oil transfer plate assembly. If there is no twine, continue to Step 2. 2. Feed wiring harness (Figure 3, Item 9) into center housing opening (Figure 3, Item 12) and pull wiring harness (Figure 3, Item 9) through oil transfer plate opening (Figure 3, Item 13). Figure 3. Wiring Harness Installation Through Oil Transfer Plate. 0014‐4