TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 97 of 620
TM 9-2520-272-40 0014 NOTE Connectors on wiring harness are identif ed by stamped letters on connectors. Each connector will have one of the letters A through G. Use of twine is not necessary if all transmission top components are to be completely removed. 5. Tie a 30 in. (762 mm) piece of twine (Figure 2, Item 11) to harness connector F or G. 6. Remove wiring harness (Figure 2, Item 9). When wiring harness has been removed from the transmission, cut the 30 in. (762 mm) piece of twine (Figure 2, Item 11) off the connector, leaving the twine installed through the harness bore. When installing or replacing the harness, tie the outside end of the twine to connector F or G and use inside end of twine to pull harness through. 7. Remove wiring harness and gasket (Figure 2, Item 10) from transmission by pulling on wiring harness connector body (Figure 2, Item 5) with one hand and feeding wiring harness (Figure 2, Item 5) through transmission with the other hand. Discard gasket (Figure 2, Item 10). Figure 2. Wiring Harness with Twine Attached for Removal. END OF TASK 0014‐3