TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 82 of 620
TM 9-2520-272-40 0010 REMOVE LOCKUP CONTROL VALVE ASSEMBLY NOTE Top cover assembly is removed from transmission. Control valve assemblies are removed with solenoids attached. Wiring harness does not have to be removed to remove lockup control valve assembly. Transmission is upright on f oor or work table. No solenoid should be removed from control valve assemblies unless procedures have established that solenoid malfunction exists. When necessary to replace a solenoid or to repair solenoid connector, refer to Replace Solenoids and Terminals, WP 0070. 1. Remove two 5/16-20 x 2-1/4 inch bolts (Figure 1, Item 1) and washers (Figure 1, Item 2) that attach lockup control valve assembly (Figure 1, Item 4) to separator plate (Figure 1, Item 5). 2. Remove four 5/16-18 x 2-3/4 inch bolts (Figure 1, Item 3) and washers (Figure 1, Item 2) that attach lockup control valve assembly (Figure 1, Item 4) to separator plate (Figure 1, Item 5). 3. Disconnect plastic connectors that attach wiring harness to solenoids. 4. Remove lockup control valve assembly (Figure 1, Item 4). 0010‐2