TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 553 of 620
TM 9-2520-272-40 0069 REMOVE TRANSMISSION FROM ADAPTER PLATE An adapter plate must be mounted on the maintenance turnover stand in order to accept the transmission. The transmission must be mounted on the adapter plate. WARNING Check slings and trestle for cuts, breaks, or wear before and during hoisting. Slings and trestle can break and cause injury or death. Transmission will tilt suddenly when weight shifts from one sling to the other. Stay clear of slings and transmission to avoid injury. Transmission weighs about 975 lb (442 kg). To avoid injury or death, keep out from under and clear of transmission at all times. Do not let transmission swing freely during hoisting. NOTE If lifting brackets must be installed on transmission, go to Step 1. If lifting brackets have not been removed from transmission, go to Step 3. 1. Install lifting brackets. Refer to TM 9-2350-277-13&P. 2. Make sure right lifting bracket (Figure 14, Item 2) is securely attached to right cover assembly (Figure 14, Item 1), and left lifting bracket (Figure 14, Item 3) is securely attached to left cover assembly (Figure 14, Item 4). Figure 14. Right and Left Lifting Brackets Mounted on Right and Left Cover Assemblies. 0069‐11