TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 540 of 620
TM 9-2520-272-40 0068 INSTALL ADAPTER PLATE ON MAINTENANCE STAND WARNING Check slings and trestle for cuts, breaks, or wear before and during hoisting. Slings and trestle can break and cause injury or death. Adapter plate weighs 127 lb (57.6 kg). Lift plate with hoist and trestle to avoid injury. NOTE An adapter plate must be mounted on the maintenance turnover stand in order to accept the transmission. 1. Install and securely tighten eyebolt (Figure 1, Item 1) in end of adapter plate (Figure 1, Item 2). 2. Using engine and transmission sling attached to hoist and trestle, position adapter plate (Figure 1, Item 2) so that six holes in adapter plate are aligned with six holes in head of maintenance stand (Figure 1, Item 3). 3. Install two 5/8-11 x 3 inch bolts (Figure 1, Item 5) and two washers (Figure 1, Item 4) through opposite sides of maintenance stand head (Figure 1, Item 3) and into adapter plate (Figure 1, Item 2) to hold alignment. 4. Install the four remaining bolts (Figure 1, Item 5) and four washers (Figure 1, Item 4) holding adapter plate (Figure 1, Item 2) to maintenance stand (Figure 1, Item 3). Tighten all six bolts (Figure 1, Item 5). 5. Torque six bolts (Figure 1, Item 5) to 160 to 175 lb-ft (217 to 237 N·m). 6. Remove engine and transmission sling. Figure 1. Adapter Plate Installation. END OF TASK 0068‐2