TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 530 of 620
TM 9-2520-272-40 0067 CARE IN HANDLING CAUTION Protective covers on threads, pilot diameters, or splines must be of such conf guration as to prevent further assembly unless the covers are f rst removed. If protective covers are left in the transmission, the transmission may not operate properly. Protect all threads, splines, and pilot diameters. Parts must be handled carefully to prevent nicking, scratching, or denting. Parts that operate with close tolerance will not function properly, even if slightly damaged. Parts requiring smooth sealing surfaces may leak if scratched. Such parts should be carefully handled and protected. Use suitable containers and parts receptacles for storage. END OF TASK CLEANING WARNING Some dry cleaning solvents are toxic and f ammable. To avoid injury, wear protective goggles and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and do not breathe vapors. Do not use near open f re or excessive heat. The f ash point for Type I dry cleaning solvent is 100°F (38°C) and for Type II is 138°F (50°C). If you become dizzy while using dry cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made, wash your eyes with water and get medical aid immediately. Failure to comply may result in injury or death to personnel. WARNING Compressed air used for cleaning purposes must not exceed 30 pounds of pressure per square inch. Use only with effective chip guards and protective personal equipment including goggles or face shield and gloves. Never blow compressed air toward another person. Failure to comply may result in injury to personnel. 0067‐2