TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 499 of 620
TM 9-2520-272-40 0060 SUSTAINMENT MAINTENANCE REPLACE HYDROSTATIC PUMP AND MOTOR ASSEMBLY INITIAL SETUP: Tools and Special Tools Adapter, Socket Wrench Drive, 3/8” Male x 1/2” Female (WP 0079, Item 2) Eyebolt, 7/8-9 Hoist, Lifting, 2000 lb Capacity (WP 0079, Item 21) Hook, Chain, S (WP 0079, Item 22) Pliers Set, Retaining Ring (WP 0079, Item 27) Sling, Engine and Transmission (WP 0079, Item 35) Stand, Maintenance, Automotive (WP 0079, Item 40) Tool Kit, General Mechanic’s (GMTK) (WP 0079, Item 45) Trestle, Hoist, 2000 lb Capacity (WP 0079, Item 46) Wrench, Torque, Dial, 3/8” Drive, 300 lb-in. (WP 0079, Item 50) Personnel Required Track Vehicle Repairer, 91H10 Equipment Condition Transmission removed from vehicle or container (TM 9-2350-277-13&P) Oil f ll tube assembly removed (WP 0006) Steer control assembly removed (WP 0050) REMOVE HYDROSTATIC PUMP AND MOTOR ASSEMBLY NOTE Transmission is right end up. 1. Remove six bolts (Figure 1, Item 3) and six washers (Figure 1, Item 4) holding the hydrostatic pump and motor assembly (Figure 1, Item 6) to transmission (Figure 1, Item 5). 2. Install 7/8-9 eyebolt (Figure 1, Item 2) in threaded hole (Figure 1, Item 1) located in center of shaft on hydrostatic pump and motor assembly (Figure 1, Item 6). Figure 1. Eyebolt Installation. 0060‐1