TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 492 of 620
TM 9-2520-272-40 0059 10.Install new O-ring (Figure 16, Item 35) onto elbow (Figure 16, Item 34). Install elbow (Figure 16, Item 34) and O-ring (Figure 16, Item 35) into bevel gear housing. Figure 16. Elbow Installation. 11.Install new O-ring (Figure 17, Item 33) onto connector (Figure 17, Item 32). Install connector (Figure 17, Item 32) and O-ring (Figure 17, Item 33) into input and scavenge pump assembly (Figure 17, Item 31). 12.Torque connector (Figure 17, Item 32) to 5 to 7 lb-ft (7 to 9 N·m). Figure 17. Connector Installation. 13.Install two clamps (Figure 18, Item 28) onto reverse signal tube (Figure 18, Item 27). 14.Remove bolt (Figure 18, Item 25) and washer (Figure 18, Item 26) (if present) from bevel gear carrier. 15.Remove bolt (Figure 19, Item 29) and washer (Figure 19, Item 30) (if present) from input and scavenge pump assembly (Figure 19, Item 31). 16.Install reverse signal tube (Figure 18, Item 27) and (Figure 19, Item 27) onto elbow (Figure 18, Item 34) and connector (Figure 19, Item 32). After ferrule is installed, torque the two nuts on the reverse signal tube (Figure 18, Item 27) and (Figure 19, Item 27) to 10 to 12 lb-ft (1 to 16 N·m). 17.Install washer (Figure 18, Item 26) and bolt (Figure 18, Item 25) that attach reverse signal tube (Figure 18, Item 27) to bevel gear assembly. 18.Torque bolt (Figure 18, Item 25) to 36 to 43 lb-ft (49 to 58 N·m). 19.Install washer (Figure 19, Item 30) and bolt (Figure 19, Item 29) that attach reverse signal tube (Figure 19, Item 27) to input and scavenge pump assembly (Figure 19, Item 31). 20.Torque bolt (Figure 19, Item 29) to 17 to 20 lb-ft (23 to 27 N·m). 0059‐12