TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 489 of 620
TM 9-2520-272-40 0059 27.Position bevel gear assembly on wooden blocks as shown in Figure 10. 28.Remove packing (Figure 10, Item 41) from sleeve of diaphragm assembly (Figure 10, Item 40). Discard packing (Figure 10, Item 41). 29.Remove nine bolts (Figure 10, Item 38) and nine washers (Figure 10, Item 39) that keep diaphragm assembly (Figure 10, Item 40) in position. Figure 10. Diaphragm Assembly Hardware Removal. 30.Install two bolts (Figure 11, Item 38) (removed in Step 29) in two jacking bolt holes (Figure 11, Item 42). 31.Tighten one jack bolt (Figure 11, Item 38) and then the other jack bolt (Figure 11, Item 38). Repeat until diaphragm assembly (Figure 11, Item 40) is loose. 32.Remove diaphragm assembly (Figure 11, Item 40). 33.Remove two jack bolts (Figure 11, Item 38). Figure 11. Diaphragm Assembly Removal. 0059‐9