TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 464 of 620
TM 9-2520-272-40 0056 31.Torque bolt (Figure 28, Item 19) (installed in Step 28) to 36 to 43 lb-ft (49 to 68 N·m). Figure 28. Second Clutch Housing Hardware Installation. 32.Apply petrolatum to thrust washer (Figure 29, Item 25) and install it on the bottom of front carrier assembly (Figure 29, Item 24). 33.Install front carrier assembly (Figure 29, Item 24) into center housing and make sure thrust washer bearing (Figure 29, Item 25) stays in place. 34.Install thrust washer (Figure 29, Item 23) onto front carrier assembly (Figure 29, Item 24). 35.Soak four friction plates (Figure 29, Item 54) in lubricating oil for two minutes prior to assembly. Install one reaction plate (Figure 29, Item 55) and then one friction plate (Figure 29, Item 54). 36.Repeat Step 35 until all f ve reaction plates (Figure 29, Item 55) and all four friction plates (Figure 29, Item 54) are installed. 37.Install retaining ring (Figure 29, Item 28). 0056‐22