TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 457 of 620
TM 9-2520-272-40 0056 9. Put bar and stud assembly (Figure 22, Item 41) inside transmission through f rst clutch piston (Figure 22, Item 46) in range pack bore and hold in place. Put shim under bar and stud assembly (Figure 22, Item 41) so bar and stud assembly is level, centered, and compresses spring retainer equally. 10.Install clutch compressor bar and stud assembly (Figure 22, Item 42) over stud, then install wing nut bar and stud assembly (Figure 22, Item 43). 11. Turn wing nut (Figure 22, Item 43) on clutch compressor (Figure 22, Item 42) until piston spring retainer (Figure 22, Item 44) compresses enough to allow installation of retaining ring (Figure 22, Item 45). 12.Reach through opening in clutch compressor (Figure 22, Item 42) and install retaining ring (Figure 22, Item 45). 13.Remove wing nut (Figure 22, Item 43) and clutch compressor (Figure 22, Item 42). Figure 22. Bar and Stud Assembly and Compressor Installed for Retaining Ring Installation. 0056‐15