TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 450 of 620
TM 9-2520-272-40 0056 24.Remove retaining ring (Figure 9, Item 28) that holds second clutch piston housing assembly (Figure 9, Item 29). Figure 9. Second Clutch Piston Housing Assembly Retaining Ring Removal. 25.Put lifter (Figure 10, Item 32) over end of shouldered shaft (range input shaft) (Figure 10, Item 35) and put lower end of lifter (Figure 10, Item 32) in groove below area of center sun gear (Figure 10, Item 34) that has splines. 26.Using thumb screw (Figure 10, Item 33) on lifter (Figure 10, Item 32), tighten bottom of lifter (Figure 10, Item 32) in groove. 27.Install tool hook (Figure 10, Item 31) in top of tool lifter (Figure 10, Item 32). 28.Use hoist (Figure 10, Item 30), trestle, tool hook (Figure 10, Item 31) and tool lifter (Figure 10, Item 32) to raise range input shaft (Figure 10, Item 35) and attached center carrier assembly (Figure 10, Item 27) until second clutch piston housing assembly (Figure 10, Item 29) is high enough to get hands under it. 29.Lower range input shaft (Figure 10, Item 35) and center carrier assembly (Figure 10, Item 27) back into center housing (Figure 10, Item 1). 30.Remove hoist Figure 10, Item 30) and tool hook Figure 10, Item 31) from tool lifter Figure 10, Item 32). NOTE Second clutch piston housing assembly has to be pulled up (one side, then the other) using two hands, to get it free. Refer to WP 0053 for repair of second clutch piston housing assembly. 31.Remove second clutch piston housing assembly (Figure 10, Item 29). 0056‐8