TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 378 of 620
TM 9-2520-272-40 0045 27.Put left brake support (Figure 19, Item 3), inside surface up, on 2 x 4 x 24 inch soft wood lumber wooden blocks (Figure 19, Item 9). 28.Install stationary cam (Figure 19, Item 12) onto two pins (Figure 19, Item 50) in support (Figure 19, Item 3). Make sure bolt holes are aligned. 29.Tap stationary cam (Figure 19, Item 12) onto pins (Figure 19, Item 50) until cam (Figure 19, Item 12) is installed. 30.Turn support (Figure 19, Item 3) over and place on 2 x 4 x 24 inch soft wood lumber wooden blocks (Figure 19, Item 3). 31.Install three washers (Figure 20, Item 6) and three bolts (Figure 20, Item 5). 32.Torque three bolts (Figure 20, Item 5) to 17 to 20 lb-ft (23 to 27 N·m). 33.Turn support (Figure 20, Item 3) over and place on 2 x 4 x 24 inch soft wood lumber wooden blocks (Figure 20, Item 9). 34.Install new hook-type metal seal ring (Figure 19, Item 10) onto retainer (Figure 19, Item 11). 35.Apply petrolatum to seal ring (Figure 19, Item 10). 36.Tilt support (Figure 19, Item 3) on edge. 37.Install retainer (Figure 19, Item 11), f at side f rst, into support (Figure 19, Item 3). Start two washers (Figure 20, Item 8) and two bolts (Figure 20, Item 7) into support (Figure 20, Item 3) to keep retainer (Figure 19, Item 11) in position. 38.Turn support (Figure 20, Item 3) over and place on 2 x 4 x 24 inch soft wood lumber wooden blocks (Figure 20, Item 9). 39.Torque two bolts (Figure 20, Item 7) to 10 to 12 lb-ft (14 to 16 N·m). Figure 19. Packing Retainer, Stationary Cam, and Seal Ring Installation. 0045‐16