TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 322 of 620
TM 9-2520-272-40 0039 NOTE Remove or install the external-splined ring gear only when the external-splined ring gear fails or when the converter pump cover assembly is replaced. 28.Install the ring gear (Figure 23, Item 5) over six studs (Figure 23, Item 7) on top of the converter pump cover assembly (Figure 23, Item 1). 29.Using plastic-faced hammer, tap ring gear (Figure 23, Item 5) until it is installed on the converter pump cover assembly (Figure 23, Item 1). 30.Use pry bar (Figure 23, Item 6) between two studs (Figure 23, Item 7) on top of the converter pump cover assembly (Figure 23, Item 1) to keep cover and ring gear (Figure 23, Item 5) from turning. 31.Install six new f ex disk nuts (Figure 23, Item 4) on the studs (Figure 23, Item 7) that attach the ring gear (Figure 23, Item 5) to the converter pump cover assembly (Figure 23, Item 1). 32.Torque six nuts (Figure 23, Item 4) to 41 to 44 lb-ft (56 to 60 N·m). Figure 23. External-Splined Ring Gear Installation. END OF TASK END OF WORK PACKAGE 0039‐22