TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 320 of 620
TM 9-2520-272-40 0039 NOTE The converter pump cover assembly has a balance mark. This balance mark must align with the balance mark on the clutch backing plate. Align the pump cover holes with the pump housing studs so that clutch backing plate balance mark will be at the nearest point under the converter pump cover assembly balance mark. 20.Dry the edge of the converter pump cover assembly (Figure 21, Item 1) that is nearest the balance mark (Figure 21, Item 33) with a wiping rag. 21.Put a mark across the edge of the converter pump cover assembly (Figure 21, Item 1) at the point nearest the pump cover balance mark (Figure 21, Item 33) using a black marker. 22.Lift the converter pump cover assembly (Figure 21, Item 1) by the two studs on top and hold the pump cover above the clutch backing plate (Figure 21, Item 11) so that the black mark on the edge of the pump cover (Figure 21, Item 32) aligns with the balance mark on the clutch backing plate (Figure 21, Item 11). 23.Put the converter pump cover assembly (Figure 21, Item 1) on the converter pump assembly (Figure 21, Item 17) studs so that the balance mark and black mark on the converter pump cover assembly (Figure 21, Item 1) are at the nearest point to the balance mark on the clutch backing plate (Figure 21, Item 11). 24.Tap the converter pump cover assembly (Figure 21, Item 1) to install the cover on the converter pump assembly (Figure 21, Item 17) studs. Figure 21. Converter Pump Cover Installation. 0039‐20