TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 313 of 620
TM 9-2520-272-40 0039 NOTE The two locking plates go over the two bolt holes on the retainers. 7. Place four new locking strips (Figure 12, Item 19) on the converter bearing retainer plates (Figure 12, Item 20), bent tabs up. 8. Install eight cap screws (Figure 12, Item 18) in locking strips (Figure 12, Item 19) and converter bearing retainer plates (Figure 12, Item 20). 9. Use a pry bar to keep the converter pump assembly (Figure 12, Item 17) from turning. Torque eight cap screws (Figure 12, Item 18) to 19 to 23 lb-ft (25 to 31 N·m). Remove pry bar. Figure 12. Converter Pump Assembly Hardware Installation. 0039‐13