TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 310 of 620
TM 9-2520-272-40 0039 INSTALL CONVERTER ELEMENT COMPONENTS NOTE Make sure that the transmission is on maintenance stand so that the input housing points up. 1. Install two 5/16-24 x 3 inch guide pins (Figure 10, Item 28) 180 degrees apart in the shoulder of the input pump drive gear (Figure 10, Item 29). 2. Install new converter pump gasket (Figure 10, Item 26) over the guide pins (Figure 10, Item 28) and on the shoulder of the input pump drive gear (Figure 10, Item 29). NOTE You will not be able to see the manufacturer’s balance mark after you install the converter pump. Using a black marker, put a mark at the location of the balance mark near a stud so that you can see it from the top view of the converter pump. 3. Install the converter pump assembly (Figure 10, Item 17) over guide pins (Figure 10, Item 28). NOTE Make sure the converter pump assembly is down far enough to allow the inner lips on the converter bearing retainer plate to touch and align with groove on bearing. 4. Tap the converter pump assembly (Figure 10, Item 17) to install the pump on gasket (Figure 10, Item 26). 5. Remove two guide pins (Figure 10, Item 28). 0039‐10