TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 277 of 620
TM 9-2520-272-40 0035 SUSTAINMENT MAINTENANCE REPLACE LEFT OUTPUT SHAFT INITIAL SETUP: Tools and Special Tools Hammer, Hand, Soft-Face, Dead Blow, 52 oz (WP 0079, Item 19) Heater, Gun-Type, Electric (WP 0079, Item 20) Press, Arbor, Hand, 25 Ton (WP 0079, Item 28) Tool Kit, General Mechanic’s (GMTK) (WP 0079, Item 45) Materials/Parts Block, Wood, Lumber, Soft Wood (WP 0078, Item 3) (2 - 16 in. lengths) Carbon Dioxide, Technical (Dry Ice) (WP 0078, Item 4) Gloves, Leather (WP 0078, Item 8) Lubricating Oil, Engine (WP 0078, Item 10) Petrolatum, Technical (Petroleum Jelly) (WP 0078, Item 12) Retainer, Packing (WP 0080, Item 39) Retainer, Packing (WP 0080, Item 53) (2) Personnel Required Track Vehicle Repairer, 91H10 (2) References TM 9-2350-277-13&P Equipment Condition Transmission removed from vehicle or container (TM 9-2350-277-13&P) Oil f ll tube assembly removed (WP 0006) Left cover assembly removed (WP 0033) REMOVE LEFT OUTPUT SHAFT NOTE Make sure that the left cover assembly is turned so that the internal side points up when it is not on its edge. Use two wooden blocks to make the left cover assembly level when you put it on its edge. Put the blocks below the corner nearest to the left output shaft. 1. Remove the retaining ring (Figure 1, Item 3) that holds the bearing assembly (Figure 1, Item 4) and the left output shaft (Figure 1, Item 2) from the left cover assembly (Figure 1, Item 1). Figure 1. Retaining Ring Removal. 0035‐1