TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 269 of 620
TM 9-2520-272-40 0033 CAUTION Damage to left cover assembly can occur if excessive force is used. Do not force the cover to seat on the transmission. Do not beat on it with a hammer or use the split line bolts to pull it into position. If the cover seems to be hung up and will not properly install, remove the left cover assembly from the transmission and verify that the correct bevel gear driven shaft is installed. Conf rm that the part identif cation and length of bevel gear driven shaft matches that which you have previously recorded during Replace Bevel Gear Drive Shaft and Filter Tubes, WP 0038. This should be P/N 29533537, with length 10.65 in. (270.51 mm), used with rear carrier assembly P/N 29533535. 12.Tap left cover assembly (Figure 8, Item 1) to seat cover against gasket on center housing assembly. 13.Torque two bolts (Figure 8, Item 4) and 29 bolts (Figure 8, Item 2) to 27 to 32 lb-ft (37 to 43 N·m). Figure 8. Left Cover Assembly Installation. END OF TASK END OF WORK PACKAGE 0033-9/10 blank