TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 256 of 620
TM 9-2520-272-40 0031 WARNING Spring-loaded parts can f y and cause injury. Always obey specif ed instructions when you install bolts in covers that are attached to valve assemblies. 11.Install reverse equalizer valve housing (Figure 6, Item 3) over spring (Figure 6, Item 4) so that bolt holes and recesses for tubes are aligned. 12.Push reverse equalizer valve housing (Figure 6, Item 3) down on spring (Figure 6, Item 4) with one hand, and use other hand to install two bolts (Figure 6, Item 1) and washers (Figure 6, Item 2). Turn bolts two or three turns to hold housing. NOTE If end of reverse equalizer piston assembly does not go through housing hole, bolts may be loosened and piston moved by putting a screwdriver through side of housing. 13.Tighten bolts (Figure 6, Item 1) carefully. End of reverse equalizer piston assembly (Figure 6, Item 6) must come through hole (Figure 6, Item 15) in top center of equalizer valve housing (Figure 6, Item 3) when bolts are tightened. 14.Torque two bolts (Figure 6, Item 1) to 36 to 43 lb-ft (48 to 58 N·m). 0031‐8