TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 242 of 620
TM 9-2520-272-40 0030 REMOVE INNER (LEFT) STEER SHAFT, RANGE OUTPUT GEAR SPACER, AND TUBES NOTE It may be necessary to lightly move the steer shaft back and forth to remove it from transmission. 1. Remove the inner (left) steer shaft (Figure 1, Item 1). 2. Remove the two retaining rings (Figure 1, Item 2) if they show damage. NOTE Do Step 3 only if sleeve (range output gear spacer) is installed. Early models of the X200-4A Transmission had a sleeve installed. This sleeve was used when older carrier and shouldered shaft parts were installed. This sleeve is not installed in later models of the X200-4A Transmission. Refer to TM 9-2520-272-40P for the current conf guration. 3. Remove the sleeve (Figure 1, Item 4) from the shaft and bushing assembly (Figure 1, Item 3). Figure 1. Inner (Left) Steer Shaft and Sleeve Removal. 0030‐2