TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 239 of 620
TM 9-2520-272-40 0029 NOTE Do Step 9 and Step 10 only if old bearing was removed. 9. Lubricate bearing (Figure 6, Item 5) journals on both sides of range output driven gear (Figure 6, Item 6) with lubricating oil and petrolatum. NOTE Bearings consist of inner race with rollers and outer races. Make sure that outer race beneath output driven gear is in left brake support assembly (refer to Repair Left Brake Support, WP 0046) and outer race above gear is in Right Cover Assembly (refer to Repair Right Cover Assembly, WP 0017). 10.Install two new bearings (Figure 6, Item 5) on range output driven gear (Figure 6, Item 6). Press bearings to shoulder. 11. Apply lubricating oil to two bearings (Figure 6, Item 5). 12.Install range output driven gear (Figure 6, Item 6) on steer ring gear assembly (Figure 6, Item 13) (located on left output shaft), with longer internal spline on gear (Figure 6, Item 6) down. NOTE Retaining rings on each end of outer (right) steer shaft serve as stops. It is not necessary to replace retaining rings that are in good condition. Outer (right) steer shaft may be installed either end f rst. 13.Install outer (right) steer shaft (Figure 6, Item 2) with retaining rings (Figure 6, Item 1) installed in steer shaft drive gear (Figure 6, Item 4). Figure 6. Range Output Driven Gear and Outer (Right) Steer Shaft Installation. END OF TASK END OF WORK PACKAGE 0029-7/8 blank