TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 206 of 620
TM 9-2520-272-40 0025 INSTALL BRAKE APPLY CAM AND BRAKE ADJUSTING LINKS 1. Install new O-rings (Figure 17, Item 9) and (Figure 17, Item 10) into face of brake apply cam (Figure 17, Item 4). CAUTION Make sure seals are installed with seal lips in direction shown in illustration. If seals are not installed properly, components will not function properly. 2. Install new seal (Figure 17, Item 6), seal lip down, in brake apply cam (Figure 17, Item 4). 3. Install new seal (Figure 17, Item 5), seal lip upward, in brake apply cam (Figure 17, Item 4). 4. Apply a layer of petrolatum to seals and O-rings (Figure 17, Item 5), (Figure 17, Item 6), (Figure 17, Item 9), and (Figure 17, Item 10). 5. Hold two spring tension clips (Figure 17, Item 12) in position on brake apply cam (Figure 17, Item 4) as shown in Figure 17. 6. Install bolt (Figure 17, Item 11) to keep clips (Figure 17, Item 12) in position. 7. Torque bolt (Figure 17, Item 11) to 108 to 132 lb-in. (12 to 15 N·m). Figure 17. Seals and O-Rings Installation. 0025‐16