TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 184 of 620
TM 9-2520-272-40 0024 CAUTION Be careful not to cut into right brake support assembly when you cut slots in the bearing race. 10.Cut two slots 180 degrees apart at the base of the bearing race (Figure 3, Item 7) as shown in Figure 2. Cut the slots slightly offset so that the pry bars will overlap. Cut the slots deep enough to catch the lip of the pry bar but not deep enough to cut into the right brake support assembly (Figure 3, Item 6). WARNING Hot parts can burn you. Always wear leather gloves when working with parts that are or might be hot. 11.Apply heat to the right brake support assembly (Figure 3, Item 6) with heat gun around the bearing race (Figure 3, Item 7) for 15 minutes. CAUTION Be careful not to damage the right brake support assembly when you use pry bars to remove the bearing race. 12.Lift up the bearing race (Figure 3, Item 7) using two pry bars in offset slots. 13.Move the two pry bars under the bearing race (Figure 3, Item 7) and remove bearing race. 0024‐4