TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 171 of 620
TM 9-2520-272-40 0023 NOTE If stationary cam is to be replaced, refer to Step 18. Do not remove the stationary cam unless: You must replace the cam or support. You must repair the support. 13.Turn right brake support assembly (Figure 4, Item 8) over so that the outside points up. Put on wooden blocks (Figure 4, Item 14). 14.Unscrew three bolts (Figure 4, Item 15) and (Figure 4, Item 17) until bolt heads are approximately 0.25 in. (6.35 mm) above the surface of the right brake support assembly (Figure 4, Item 8). 15.Tap down bolt heads (Figure 4, Item 15) and (Figure 4, Item 17) to touch surface of right brake support assembly (Figure 4, Item 8). 16.Remove two bolts (Figure 4, Item 15) and two washers (Figure 4, Item 16) from right brake support assembly (Figure 4, Item 8). 17.Remove bolt (Figure 4, Item 17) and washer (Figure 4, Item 18) from right brake support assembly (Figure 4, Item 8). Figure 4. Bolts and Washers Removal. 0023‐5