TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 160 of 620
TM 9-2520-272-40 0021 INSTALL LEFT BRAKE APPLY SHAFT CAUTION Put protective material, such as masking tape, on the splines. If the shaft goes through the seal without protection, the splines on the shaft will cause damage to the seal. NOTE Make sure that the right cover assembly is turned so that the internal side points up. Put the right cover assembly on wooden blocks. If there is tape on splines, put petrolatum on tape before you install shafts. 1. Apply petrolatum to washer (Figure 4, Item 7). 2. Install washer (Figure 4, Item 7) on the left brake apply shaft (Figure 4, Item 1). 3. Clean the spline end of the left brake apply shaft (Figure 4, Item 1). 4. Wind masking tape around the spline and end of left brake apply shaft (Figure 4, Item 1). 5. Apply petrolatum on tape on the left brake apply shaft (Figure 4, Item 1). 6. Put the taped end of the left brake apply shaft (Figure 4, Item 1) above the bearing (Figure 4, Item 8) in the right cover assembly (Figure 4, Item 5). Figure 3. Left Brake Apply Shaft Prepared for Installation. 0021‐4