TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 144 of 620
TM 9-2520-272-40 0019 REMOVE BRAKE APPLY REGULATOR VALVE COMPONENTS WARNING Spring-loaded parts can f y and cause you injury. Always obey specif ed instructions when you remove bolts from covers that are attached to valve assemblies. NOTE Make sure that the right cover assembly is turned so that the internal side points up. 1. Push on the brake apply regulator valve assembly (Figure 1, Item 2) head to move the brake apply regulator valve assembly toward brake apply valve body (Figure 1, Item 8) and to compress the spring (Figure 1, Item 3). Use one hand to hold the valve in. 2. Using the other hand, insert a 1/32-in. stock shim (Figure 1, Item 7) behind the nut (Figure 1, Item 6) to hold the brake apply regulator valve assembly (Figure 1, Item 2). Release brake apply regulator valve assembly. 3. Remove f ve bolts (Figure 1, Item 5) and washers (Figure 1, Item 4) from the valve body (Figure 1, Item 8). 4. Remove the valve body (Figure 1, Item 8) and the separator plate (Figure 1, Item 9) from the right cover assembly (Figure 1, Item 1). 5. Push on brake apply regulator valve assembly (Figure 1, Item 2) head to compress spring (Figure 1, Item 3) and remove stock shim (Figure 1, Item 7) from behind nut (Figure 1, Item 6). Release valve slowly. 6. Remove brake apply regulator valve assembly (Figure 1, Item 2) and spring (Figure 1, Item 3) from valve body (Figure 1, Item 8). 0019‐2