TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 134 of 620
TM 9-2520-272-40 0017 23.Turn right cover assembly (Figure 14, Item 1) over, outside up. 24.Apply petrolatum and lubricating oil to outer diameter of two brake apply shaft bearings (Figure 14, Item 2) and (Figure 14, Item 3). NOTE Press brake apply shaft bearings with driver against numbered side of bearings. 25.Install two brake apply shaft bearings (Figure 14, Item 2) and (Figure 14, Item 3) in right cover assembly (Figure 14, Item 1). Push brake apply shaft bearings 0.030 to 0.040 in. (0.762 to 1.016 mm) in from brake apply shaft seal (Figure 14, Item 4) and (Figure 14, Item 5) shoulders. NOTE Install brake apply shaft seal with numbered side of seal against seal inserter. Small end of seal inserter tool is used for brake apply shaft seals. Brake apply shaft seal contains dry-type sealer on outer edge. 26.Install brake apply shaft seals (Figure 14, Item 4) and (Figure 14, Item 5) in right cover assembly (Figure 14, Item 1) using seal inserter. Push brake apply shaft seals to 0.080 in. (2.032 mm) below surface of right cover assembly. WARNING Hot parts can burn you. Always wear leather gloves when working with parts that are or might be hot. 27.Apply heat to new sleeve (Figure 14, Item 14). Heat for 15 minutes to 300°F (149°C). 0017‐14