TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 114 of 620
TM 9-2520-272-40 0016 NOTE Two legs of the multiple-leg sling are used in this task. When the sling bolts are tightened, they loosen the right cover from transmission. 7. Install one 3/8-inch washer (Figure 3, Item 11) on each of two 3/8-16 x 2 inch bolts (Figure 3, Item 10), and install bolts (Figure 3, Item 10) through lugs of multiple-leg sling (Figure 3, Item 12). 8. Install one bolt (Figure 3, Item 10) protruding from sling lug (Figure 3, Item 12) into each hole (Figure 3, Item 13) on right cover assembly (Figure 3, Item 1). 9. Tighten one bolt (Figure 3, Item 10) then the other bolt (Figure 3, Item 10) until right cover assembly (Figure 3, Item 1) loosens. 10.Strike elbow (Figure 3, Item 15) lightly to loosen right cover assembly (Figure 3, Item 1). WARNING Check sling and trestle for cuts, breaks, or wear before and during hoisting. Slings and trestle can break and cause injury or death. You must lift right cover assembly using sling, hoist, and trestle. To avoid injury, keep clear of right cover at all times. Do not let right cover assembly swing freely during lift. 11. Remove right cover assembly (Figure 3, Item 1) using lifting hoist, trestle, and multiple-leg sling. NOTE Outer steer shaft, lube tube, and brake coolant tube may also be lifted out when right cover assembly is removed. Stow right cover assembly before removing multiple-leg sling. 12.Remove two bolts (Figure 3, Item 10), two washers (Figure 3, Item 11), and multiple-leg sling from right cover assembly (Figure 3, Item 1). 13.Remove right cover gasket (Figure 3, Item 14). Discard gasket (Figure 3, Item 14). 0016‐4