TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 109 of 620
TM 9-2520-272-40 0015 8. Install separator plate (Figure 9, Item 3) over four guide pins (Figure 9, Item 14) and on oil transfer plate assembly (Figure 9, Item 10). 9. Install f ve 5/16-18 x 1-1/2 inch bolts (Figure 9, Item 6) and f ve washers (Figure 9, Item 5) that attach separator plate (Figure 9, Item 3), oil transfer plate assembly (Figure 9, Item 10), and new gasket (Figure 9, Item 12) to transmission. 10.Torque f ve bolts (Figure 9, Item 6) to 17 to 20 lb-ft (23 to 27 N·m). 11.Install two 1/4-18 x 1-1/4 inch f anged-head bolts (Figure 9, Item 4) that attach separator plate (Figure 9, Item 3), oil transfer plate assembly (Figure 9, Item 10), and new gasket (Figure 9, Item 12) to transmission. 12.Torque two f anged-head bolts (Figure 9, Item 4) to 9 to 11 lb-ft (12 to 15 N·m). 13.Install 1/4-18 x 1-1/2 inch bolt (Figure 9, Item 1) and washer (Figure 9, Item 2) that attach separator plate (Figure 9, Item 3), oil transfer plate assembly (Figure 9, Item 10), and new gasket (Figure 9, Item 12) to transmission. 14.Torque bolt (Figure 9, Item 1) to 9 to 11 lb-ft (12 to 15 N·m). 15.Remove two 5/16-18 x 3 inch guide pins (Figure 9, Item 14) located outside the edges of the separator plate (Figure 9, Item 3). Two guide pins (Figure 9, Item 14) that go through the separator plate (Figure 9, Item 3) will stay installed. Figure 9. Oil Transfer Plate Bolts Installation. END OF TASK END OF WORK PACKAGE 0015-7/8 blank