TM-9-2520-272-40 Direct Support for M113A3 X200-4A Transmission 2520-01-397-1074 Download
Page 100 of 620
TM 9-2520-272-40 0014 INSTALL WIRING HARNESS NOTE Connectors on solenoids and connectors on wiring harness look the same except for color. Connectors are mated by pushing them together with connector loops over bayonets. Connectors are locked in place when ends of loops are down behind bayonets. All solenoids are the same and they are interchangeable. For that reason, solenoid connectors are not marked with solenoid identif cation. However, each lead of the wiring harness must go to a specif c solenoid location. The letter stamped on the wiring harness connector indicates location of solenoid to be connected. Locations of solenoid A (Figure 5, Item 20), solenoid B (Figure 5, Item 19), solenoid C (Figure 6, Item 21), solenoid D (Figure 5, Item 22), solenoid E (Figure 5, Item 18), solenoid F (Figure 5, Item 17), and solenoid G (Figure 5, Item 16) are shown in Figure 5. Figure 5. Solenoid Locations. 1. Look for letters A, B, C, D, E, F, and G stamped on wiring harness connectors (Figure 6, Item 7). 2. Locate solenoids A, B, E, F, and G (Figure 7, Item 20) and (Figure 7, Item 19) and (Figure 7, Item 18) and (Figure 7, Item 17) and (Figure 7, Item 16) on main control valve assembly (Figure 7, Item 1) and locate solenoids C and D (Figure 7, Item 21) and (Figure 7, Item 22) on lockup control valve assembly (Figure 7, Item 26). 3. Match wiring harness connectors (Figure 6, Item 7) and (Figure 7, Item 7) with solenoid connectors (Figure 6, Item 25) and (Figure 7, Item 25). 4. Hold wiring harness connector (Figure 6, Item 7) and (Figure 7, Item 7) and solenoid connector (Figure 6, Item 25) and (Figure 7, Item 25) with ends of connectors facing each other. 5. Align connectors (Figure 6, Item 7) and (Figure 6, Item 25) so that connector loops (Figure 6, Item 24) will f t over bayonets (Figure 6, Item 23). 0014‐6