TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 96 of 126
Figure 5-91 Figure 5-93 Figure 5-92 Figure 5-94 Install two guide bolts (A) into pitot tube (B), and insert guide bolts into housing (C). Install reverse planetary carrier and pitot collector ring assembly (D) so that pitot tube (B) will be located in collector ring at position shown by arrow head (E) between vanes. (Guide bolts are part of set 4910- 572-8710 (8356165).) Remove one guide bolt (A), and install a 1 / 4 -28 x 2 3 / 4 bolt (B) and plain washer to hold pitot tube in place. Remove other guide bolt, and install other bolt and washer. Tighten bolts to 8 to 10 pound- feet torque. (Guide bolts are part of set 4910-572- 8710 (8356165).) Place low and reverse piston housing assembly (A) on work table, reverse end up. Install reverse clutch apply plate (B), one internal-splined plate (C), and reverse ring gear (D). Alternately install three external-tanged (A) and three internal-splined (B) clutch plates. Install 12 springs (C) into reaction plate (D). Install reverse clutch reaction plate assembly (D). NOTE Aline anchor pin slot (E) with clutch apply oil holes (F). 5-46