TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 86 of 126
Figure 5-79. Section IX. OVERHAUL (REBUILD) OF NOTE If the assembly is worn or damaged such that the operation below will not restore it to serviceable condition, replace entire assembly. 5-37. Description Refer to paragraph 2-10 for description of the transmission output shaft assembly. 5-38. Disassembly (fig. 5-74) NOTE All items not covered below were removed from the transmission as outlined in paragraph 5-6, steps 42 and 43 (fig. 5-42 and 5-43). No further disassembly of those parts is required. If bushing (44) is worn or damaged such that replacement is necessary, remove bushing from bore. Do not damage bushing bore when removing bushing. 5-39. Cleaning Refer to paragraph 5-2 for cleaning recom- mendations. 5-40. Inspection and Repair Refer to paragraph 5-3 for general inspection and repair recommendations. Repair and overhaul (rebuild) points of measurement for fits, clearances, and wear limits are indicated by sm all letters in figure 5-74. Refer to paragraph 6-3 and table 6-3 for general wear limits information. 5-41. Assembly (fig. 5-74) NOTE All items not covered below are installed as Section X. OVERHAUL (REBUILD) OF TRANSMISSION OUTPUT SHAFT ASSEMBLY 5-42. Description Refer to paragraph 2-8 for description of the transmission housing assembly. 5-43. Disassembly (fig. 5-81) NOTE All items not covered in sand b below were removed from the transmission as outlined in paragraph 5-6, steps 50 and 51 (fig. 5-50 and 5-51). No further disassembly of those parts is required. outlined in paragraph 5-58, steps 14 through 16 (fig. 5-96 through 5-98). No overhaul (rebuild) of such components is required or recommended. If bushing (44), was removed, install new bushing using replacer 5120-759-5415 and handle 5120- 316-9182. Drive until replacer bottoms against output shaft (fig. 5-79). TRANSMISSION HOUSING ASSEMBLY a. Do not remove shift lever sleeve (fig. 5-80) from transmission housing unless replacement is necessary. If necessary, remove by driving sleeve from inside of housing to outside. Be careful not to damage sleeve bore. b. Do not remove speedometer bushing (6) from transmission housing (8) unless replacement is necessary. If necessary to remove bushing, be careful not to damage bushing bore. In some transmission this bushing will not be used because a speedometer drive is not required. 5-36