TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 85 of 126
Figure 5-77. Figure 5-78. Section VIII. OVERHAUL PLANETARY NOTE If the assembly is worn or damaged such that the operations below will not restore it to serviceable on, replace entire assembly. 5-32. Description Refer to paragraph 2-5 for description of the reverse-range planetary carrier assembly. 5-33. Disassembly (fig. 5-75) NOTE All items not covered below were removed from the transmission as outlined in paragraph 5-6, steps 46 through 50 (fig. 5- 46 through 5-50). No further disassembly of those parts is required. If rear pitot collector ring (29) is damaged in any way, press out three riveta (30), and remove collector ring and three washers (31) from reverse-range planetary carrier (32). 5-34. CIeaning Refer to paragraph 5-2 for cleaning recom- mendations. 5-35. Inspection and Repair Refer to paragraph 5-3 for repair recommendations. general inspection and Repair and overhaul (REBUILD) OF REVERSE-RANGE CARRIER ASSEMBLY (rebuild ) points of measurement for fits, clearances, and wear limits are indicated by small letters in figure 5-75. Refer to paragraph 6-3 and table 6-3 for general wear limits information. 5-36. Assembly (fig. 5-75) NOTE All items not covered in a through c below are installed as outlined in paragraph 5-58, steps 3 through 10 (fig. 5-85 through 5- 92). No overhaul (rebuild) of such com- ponents is required or recommended. a. If rear pitot collector ring (29) is being replaced, place ring on hub side of carrier (32) with large opening up. b. Install three washers (31) on three rivets (30), and insert rivets through collector ring and into carrier. c. Support rivet heads and, using a press, cold- form head on flat side of carrier to 0.030-inch minimum height with approximately 6 tons press load per rivet. d. Using oil-soluble grease to retain it, install thrust washer (19) into counterbore at front of carrier assembly (21). 5-35