TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 64 of 126
Figure 5-43 Figure 5-42 Figure 5-40 Figure 5-41 Remove intermediate back plate assembly (A). Remove two internal-splined plates (B) and two external-tanged plates (C). Remove intermediate- range ring gear (D), and remaining inter nal-splined late (E) and apply plate (F). Remove in- termed iate-range clutch piston housing (G) piston assembly. and Remove three external-tanged plates (A), three intern al-splined plates (B), and apply plate (C). Remove snap ring (D) securing intermediate carrier (E) in low-range ring gear (F). Remove intermediate carrier (E). Position remaining assembly with output shaft (A) up. Remove wire-type locating snap ring (B) from output shaft (A). Remove snap ring (C) securing reverse sun gear (D). Remove reverse sun gear (D), splined thrust washer, and spacer (under sun gear). . Remove low-range planetary assembly, ring gear (A). and reverse sun gear shaft (B) from reverse clutch assembly (C). Remove snap ring (D). Remove reverse sun gear shaft (B) from ring gear (A). 5-14