TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 61 of 126
Figure 5-31 Figure 5-33 Figure 5-32 Figure 5-30 Install two special bolts 4910-572-8701 (8356186) (A) each side, through upper-rear bolt holes in power takeoff pads. Tighten bolts to 10 to 12 pound-feet torque. These bolts secure intermediate clutch back plate (B) during disassembly. Using three puller bolts 4910-572-8699 (8356200) (A) loosen and remove diaphragm assembly (B). Remove shims (under diaphragm). CAUTION Tighten puller bolts (A) evenly to avoid cramping diaphragm (B) in its bore. NOTE A needle bearing assembly and washer may come off with diaphragm assembly. If they did, inspect underside of diaphragm, and remove them. 5-11