TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 117 of 126
Table 6-1. CHAPTER 6 REPAIR AND OVERHAUL (REBUILD) STANDARDS 6-1. Standard Torque Specifications Refer to table 6-1 for standard torque specifications for bolts, nuts, and screws. Special torque specifications are included in applicable overhaul (rebuild) and assembly sections. 6-2. Spring Specifications Refer to table 6-2 for specifications for all springs in the transmission. 6-3. General Wear Limits Information a. Wear Limits Definition. The wear limits indicate the dimensions to which a part may wear before it must be replaced. Normally any part not worn beyond its wear limit will be approved for continued use, if it is not otherwise damaged. b. Points of Measurement. Points of measurement of all critical dimensions are in- dicated by lower-case letters in the referenced figures. c. Wear Limits Tabulation. All wear limits applicable to transmission parts are tabulated in paragraph 6-4 below. d. Letters and Symbols in Tabulation. The “Size and Fit of New Parts” column indicates fit by T or L. T denotes a tight (interference) fit; L denotes a loose (clearance) fit. 6-4. Wear Limits Refer to table 6-3 for wear limits for direct and general support, maintenance operations. NOTE Refer to paragraph 5-3 for inspection recommendations applicable to all trans- mission componets. 6-1