TM-9-2520-254-34 Direct Support for M113 TX100-1 Transmission 2520-00-066-4240 Download
Page 105 of 126
Figure 5-125 Figure 5-126 Figure 5-128 Figure 5-127 Lock output flange bolt (A) by bending lock tab (B) against a flat side of bolt head. Stake edge of washer into hole (C) in flange (D). Install six small jumper tubes (A) with seal rings (B) at six places (C). NOTE Do not interchange seal rings on ends of tubes since there is a difference in size. Install large jumper tube (A) and seal rings (B). Install a retaining ring (C) in each of six small jum per tube holes. NOTE There are no grooves; seat retaining rings against jumper tubes. Install rear pump check ball (A) (nylon) in cavity (B) in transmission housing. 5-55